Novadur Concrete Remover and Cement Haze Remover Forte 25 kg
Novadur Betonlöser Forte cleans concrete mixing vehicles, construction machinery and equipment from concrete and mortar deposits
(layers, veils, incrustations) and at the same time dissolves the rust film. Novadur Betonlöser Forte is high-yielding and inexpensive. Special inhibitors prevent metal dissolution. Rubber and coatings are not attacked. Novadur Betonlöser Forte is also very suitable for cement film removal on acid-resistant floors (dilute 1:10).
PRODUCT ADVANTAGES:
- Dissolves concrete, mortar and cement excellently
- Highly effective and inexpensive
- Metals are effectively protected from corrosion by built-in inhibitor
- No damage to rubber and coatings
- Effective chemical decomposition of adhesions
- Preservation of the value of the vehicle fleet
Application:
Prostar concrete solvent is usually diluted 1:1 to 1:2 with water.
Higher concentration and the application of warm water accelerate the dissolving process
The material is applied by brushing or spraying
For immersion bath application (dilution 1:2 to 1:4), use plastic tubs as storage vessels
The crusts are chemically decomposed, soften and can thus be removed with a hard brush or spatula
In case of thicker layers, repeated treatment is necessary
Do not allow the surface to dry, but brush it off after a few minutes and spray it again.
Rinse cleaned surfaces with clear water
Sprinkle floor surfaces with slaked lime to prevent overflow of material
Special instructions:
CAUTION: Novadur Betonlöser Forte must not be applied to acid-sensitive materials (e.g. marble)!
Indication of ingredients /EG-recommendation 89/542/EEC:
Non-ionic surfactants, inorganic acids, corrosion inhibitors, traces of dye.
Classification according to Directive 67/548/EEC or 1999/45/EC (extract from the EC Safety Data Sheet according to Regulation No. 1907/2006)
Hazard designations: C - Corrosive
R-phrases:
Causes burns.
Classification according to Regulation (EC) No 1272/2008 [CLP].
Hazard Categories:
Acute Toxicity: Acute Tox. 4.
Skin corrosion/irritation: Skin cor. 1B
Serious eye damage/eye irritation: Eye Dam. 1
Specific target organ toxicity (single exposure): STOT inm. 3
Hazard statements:
Harmful if swallowed.
Causes severe skin burns and eye damage.
May cause respiratory irritation.
2.2 Label elements
Hazard determining component(s) for labeling
Hydrochloric acid techn. 31
Isotridecanol, ethoxylated (>7 - <15 EO)
Signal word: Danger
Pictograms: GHS05-GHS07
H302 Harmful if swallowed.
H314 Causes severe skin burns and eye damage.
H335 May cause respiratory irritation.
Hazard statements
P280 Wear protective gloves/protective clothing/eye protection/face protection.
P301+P312 IF INFECTED: If you feel unwell, call a POISON CENTER/doctor.
P303+P361+P353 IF ON SKIN (or hair): Remove all contaminated
Remove all contaminated clothing immediately. Wash skin with water/shower.
P304+P340 IF INHALED: Remove to fresh air and allow person to breathe freely.
unobstructed breathing.
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes.
Remove existing contact lenses if possible. Continue to rinse.
Safety Information
For further information, please refer to the supplied Safety Data Sheet according to EC Directive 91/155/EEC.
Always read the label and product information before use!
Container: 25 kg canister
One quantity unit corresponds to 1 piece!
Pictures may contain optional Accessories.
The pictures shown are for reference only, the actual product may differ.
